Oberheim TEO-5 Editor Manual

 Introduction

The TEO-5 editor was built using CTRLR 5.3.198 for Mac and on PC. The Mac versions have been tested on Catalina 10.15 but users of later Macs report it runs as a standalone app on M1 and later. The plugins do not run on Silicon. PC versions have been built on Windows 7 and tested on Windows 10. Special thanks to RomanKubiak who developed CTRLR. The editor is free and without warranty. I accept no liability for loss or damage. However, MIDI messages are unlikely your damage your synth and you can always do a firmware reset if you have problems.

Installation

MIDI Setup

Global Settings

The editor uses SYSEX and NPRN commands so these must be enabled:

1 Global menu

2 Select the following parameters:

18 - MIDI ParamSend NPRN

19 - MIDI ParamRcv NPRN

20 - MIDI Control On

21 - MIDI Sysex On

22 - MIDI Sysex Cable USB

23 - MIDI Select Out All

24 - MIDI Prog Snd On

25 - MIDI Prog Rcv On

Some of these settings are on by default but worth checking.